Numerical Investigation of Multi-Stage Hybrid Darrieus–Savonius Hydrokinetic Turbine Performance with Fibonacci Blades and Darrieus Solidity Variations

Dimas Rio Javani; Sutardi

doi:10.70716/reswara.v4i3.544

Authors

Dimas Rio Javani Department of Mechanical Engineering, Institut Teknologi Sepuluh Nopember, Surabaya, Indonesia Author
Sutardi Department of Mechanical Engineering, Institut Teknologi Sepuluh Nopember, Surabaya, Indonesia Author

DOI:

https://doi.org/10.70716/reswara.v4i3.544

Keywords:

CFD, Hybrid Turbine, Moment Coefficient (Cm), Power Coefficient (Cp), Fibonacci Spiral, Solidity

Abstract

Indonesia’s increasing energy demand and fossil fuel crisis have accelerated the transition toward New and Renewable Energy (NRE). With an NRE potential of 3,600 GW and utilization still below 2%, hydrokinetic turbines offer a promising solution for harnessing water flow energy. This study numerically investigated the performance of a multi-stage hybrid Darrieus–Savonius hydrokinetic turbine using Computational Fluid Dynamics (CFD). The proposed design combined Fibonacci spiral-based Savonius blades with NACA 0018 Darrieus blades. Simulations were conducted within a Tip Speed Ratio (TSR) range of 0.2–2.3 and solidity ratios of 0.5–1.1 to determine the optimum turbine performance. The results showed that blade solidity significantly influenced energy extraction efficiency in a non-linear manner. The optimum condition was achieved at a solidity ratio of 0.95 and TSR = 1, producing a maximum power coefficient (Cp) of 0.082. Flow visualization indicated stable negative pressure regions and higher local flow acceleration, which reduced flow separation around the blades. In contrast, a solidity ratio of 1.1 at TSR 0.8 caused stronger blockage effects and wake interactions, increasing hydrodynamic drag and reducing turbine performance. These findings demonstrate that solidity ratios close to unity can improve torque stability and turbine efficiency under low TSR conditions.

References

Chhin, S. (2020). Numerical simulations on hybrid Savonius–Darrieus wind turbine with varying airfoil shape and solidity ratio [Master's thesis, Institut Teknologi Sepuluh Nopember].

Damota, J. B., García, J. D. D. R., Casanova, A. C., Miranda, J. T., Caccia, C. G., & Galdo, M. I. L. (2022). Analysis of a nature-inspired shape for a vertical axis wind turbine. Applied Sciences, 12(14), Article 7018. https://doi.org/10.3390/app12147018

Daróczy, L., Janiga, G., Petrasch, K., Webner, M., & Thévenin, D. (2015). Comparative analysis of turbulence models for the aerodynamic simulation of H-Darrieus rotors. Energy, 90, 680–690. https://doi.org/10.1016/j.energy.2015.07.102

Galdo, M. I. L., Rodríguez García, J. D. D., Couce Casanova, A., Blanco Damota, J., Caccia, C. G., Rebollido Lorenzo, J. M., & Telmo Miranda, J. (2024). Enhanced performance of a hydrokinetic turbine through a biomimetic design. Journal of Marine Science and Engineering, 12(8), Article 1312. https://doi.org/10.3390/jmse12081312

Ghafoorian, F., Hosseini Rad, S., & Moghimi, M. (2025). Enhancing self-starting capability and efficiency of hybrid Darrieus–Savonius vertical axis wind turbines with a dual-shaft configuration. Machines, 13(2), Article 87. https://doi.org/10.3390/machines13020087

Hartanto, D. (2022). Analisis numerik pengaruh konfigurasi passive flap terhadap performansi vertical axis hydrokinetic turbine pada kanal terbuka [Undergraduate thesis, Institut Teknologi Sepuluh Nopember].

Irawan, E. N., Shibuya, K., Yamashita, K.-I., & Fujita, G. (2024). Solidity effects on small hybrid Savonius-Darrieus wind turbine performance: Experimental analysis with NREL S809 airfoil. In 2024 10th International Conference on Applied System Innovation (ICASI) (pp. 163–165). IEEE. https://doi.org/10.1109/ICASI60819.2024.10547931

Kadiri, M., Ahmadian, R., Bockelmann-Evans, B., Rauen, W., & Falconer, R. A. (2012). A review of the potential water quality impacts of tidal renewable energy systems. Renewable and Sustainable Energy Reviews, 16(1), 329–341. https://doi.org/10.1016/j.rser.2011.07.160

Kanyako, F., & Janajreh, I. (2014). Numerical investigation of four commonly used airfoils for vertical axis wind turbine. In M. O. Hamdan, H. A. N. Hejase, H. M. Noura, & A. A. Fardoun (Eds.), ICREGA'14—Renewable energy: Generation and applications (pp. 443–454). Springer. https://doi.org/10.1007/978-3-319-05708-8_35

Kementerian Energi dan Sumber Daya Mineral. (2023). Presiden Joko Widodo: Indonesia kaya potensi EBT, manfaat bagi masa depan bumi. https://www.esdm.go.id/id/media-center/arsip-berita/presiden-joko-widodo-indonesia-kaya-potensi-ebt-manfaat-bagi-masa-depan-bumi

Kumar, R., Kumar, L., Mirjat, N. H., & Harijan, K. (2023). Simulation study on the effect of cover tilt angle of solar still on its productivity. VFAST Transactions on Mathematics, 11(2), 63–76. https://doi.org/10.21015/vtm.v11i2.1586

Lanzafame, R., Mauro, S., & Messina, M. (2014). 2D CFD modeling of H-Darrieus wind turbines using a transition turbulence model. Energy Procedia, 45, 131–140. https://doi.org/10.1016/j.egypro.2014.01.015

Maldar, N. R., Ng, C. Y., & Oguz, E. (2021). A review of the hybrid Darrieus-Savonius turbine for hydrokinetic applications. In 2021 Third International Sustainability and Resilience Conference: Climate Change (pp. 424–431). IEEE. https://doi.org/10.1109/IEEECONF53624.2021.9668166

Menter, F. R. (1994). Two-equation eddy-viscosity turbulence models for engineering applications. AIAA Journal, 32(8), 1598–1605. https://doi.org/10.2514/3.12149

Mohan Kumar, P., Sivalingam, K., Lim, T.-C., Ramakrishna, S., & Wei, H. (2019). Strategies for enhancing the low wind speed performance of H-Darrieus wind turbine. Clean Technologies, 1(1), 185–204. https://doi.org/10.3390/cleantechnol1010013

Raditya Yudistira, D., Nindito, D. A., & Saputra, R. H. (2021). Kinerja turbin hidrokinetik tornado Savonius. Jurnal Teknika: Jurnal Teoritis dan Terapan Bidang Keteknikan, 4(2), 181–186. https://doi.org/10.52868/jt.v4i2.2732

Rendi, & Hartadi, B. (2022). Pengaruh kelengkungan deflektor turbin Savonius modifikasi untuk turbin hidrokinetik. Al Jazari: Jurnal Ilmiah Teknik Mesin, 7(1). https://doi.org/10.31602/al-jazari.v7i1.7106

Rogelio, M. O., García, J. C., Gómez, L. C., Vera-Wilimek, I., Jaramillo, Ó. A., & Ramirez, J. O. D. (2025). Influence of profile geometry on the self-starting capability of an H-Darrieus turbine. International Journal of Renewable Energy Development, 14(4), 694–702. https://doi.org/10.61435/ijred.2025.61124

Saini, G., & Saini, R. P. (2020). Comparative investigations for performance and self-starting characteristics of hybrid and single Darrieus hydrokinetic turbine. Energy Reports, 6, 96–100. https://doi.org/10.1016/j.egyr.2019.11.047

T. G., S., Shashikumar, C. M., Gumtapure, V., & Madav, V. (2024). Comprehensive analysis of blade geometry effects on Savonius hydrokinetic turbine efficiency: Pathways to clean energy. Energy Conversion and Management: X, 24, Article 100762. https://doi.org/10.1016/j.ecmx.2024.100762

Wilcox, D. C. (2010). Turbulence modeling for CFD (3rd ed.). DCW Industries.

Zamani, M., Nazari, S., Moshizi, S. A., & Maghrebi, M. J. (2016). Three-dimensional simulation of J-shaped Darrieus vertical axis wind turbine. Energy, 116, 1243–1255. https://doi.org/10.1016/j.energy.2016.10.031